E-Mu Xtreme Lead-1 Specifications Page 25
- Page / 241
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Xtreme Lead-1 Operation Manual 25
Setup
Instant Gratification
Instant
Gratification
This section presents step-by-step instructions for the most fundamental
operations to get you up and making sounds quickly.
Playing Demo
Sequences
Xtreme Lead has several factory demonstration sequences that let you hear
what this incredible machine can do. The actual number of demo
sequences depends on which ROM sounds sets are installed. You can play
these demo sequences by accessing the Demo Sequence page.
þ To Play a Demo Sequence
1. Press and hold the Master and Edit buttons at the same time to enter
the Demo Sequence page. The screen shown above appears.
2. Select a sequence using the data entry control. The Enter LED will be
flashing.
3. Press the Enter button to begin playing the selected sequence. The
screen shown below appears.
4. Press the Enter button again to stop playing the sequence.
5. When a demo sequence plays to the end, the next demo will automati-
cally begin playing. The screen will display the new demo name.
6. With the sequence stopped, press either the Master, Edit or Multi
button to Exit the demo sequence mode.
Auditioning Presets The front panel audition button allows you to hear any preset in Xtreme
Lead without even hooking up a MIDI keyboard! When the Audition
button is pressed, the LED next to the button will illuminate and a short
“Riff” (programmed as part of the preset) will play. The Riff is latched on
and plays continuously until the button is pressed again. Presets can be
changed while Audition is latched on.
The top line of the display changes to show the MIDI Bank Select controller
values needed to select the preset being auditioned. This is an extremely
handy feature when sequencing.
DEMO SEQUENCES XLEAD
XL
UPeople
PLAYING: XL UPeople
Press ENTER to stop
- Table of Contents 1
- Introduction 9
- Overview 10
- Important Safety 11
- Instructions 11
- Maintenance 12
- Save These Instructions 13
- Radio and 13
- Television 13
- Interference 13
- Foreign Language Warnings 14
- - German 14
- PERSONEN 15
- - French 17
- Interférences 19
- Radio et 19
- Télévision 19
- Declaration of Conformity 20
- Connection 22
- Studio Setup 23
- 24 E-MU Systems 24
- Connection Instructions 24
- Instant 25
- Gratification 25
- R A:off USER 26
- Bank Organization 27
- Main Groove 28
- Alt. Groove 28
- BEATS TRIGGER LAYOUT 29
- EMULATOR 31
- Basic Operations 33
- Controller 35
- KNOBS DEEP EDIT 36
- 37
- R 38
- bts: Logic 39
- C01 V127 P01 39
- A:off USER 39
- To Change the Channel Pan 40
- Navigator 41
- Multitimbral 42
- Operation 42
- Arpeggiator/Beats 43
- 120 bpm (current: 182) 44
- Arpeggiator/Beats Menu 46
- SuperBEATS 46
- Beats Channel (BtsCh) 47
- Trigger Channel (TrigCh) 47
- To Play BEATS (Quick Start) 47
- Beat Busy (BtsBusy) 48
- Brings in Parts 49
- Removes Parts 49
- Negative Offset 51
- BEATS PART TRANSPOSE 52
- +00 semitones 52
- To Assign a Part to a Group 53
- To Assign the Master Riff 53
- To Set the Riff Tempo Mode 54
- C01 V127 P00 56
- A:P USER 56
- arp: Sine Drum 56
- Arpeggiator 57
- 58 E-MU Systems 58
- Note value has no effect 59
- “pattern.” 59
- 60 E-MU Systems 60
- The note-on time is used 60
- “Duration” on page 63 60
- Master Arpeggiator Parameters 61
- Key Sync 62
- Quantize 62
- Pre-Delay Duration Post-Delay 64
- User Patterns 65
- To Select the Pattern to Edit 66
- + OffsetOffset 67
- To Edit a User Pattern 68
- To Name a User Pattern 69
- Multi-Channel 70
- Arpeggiating 70
- Using a MIDI 71
- Interface to 71
- Channelize 71
- 72 E-MU Systems 72
- Master Menu 73
- MASTER VELOCITY CURVE 75
- 76 E-MU Systems 76
- Defining Master Parameters 76
- Master FXA 78
- Algorithm 78
- MASTER FXA ALGORITHM 78
- Selected 83
- 86 E-MU Systems 86
- MIDI Parameters 86
- Current Multisetup 88
- Program /Preset Map 88
- All User Tuning Tables 88
- Multimode Map 88
- SEND MIDI SYSEX DATA 89
- Summing Nodes 92
- Envelope 95
- Generators 95
- Oscillators 97
- Negative Amount 98
- LFO Wave 98
- Triggered LFO 98
- Modulation 100
- Destinations 100
- Processor 101
- Flip-Flop 102
- Quantizer 102
- Lag Inputs 102
- Processors 103
- Real Rocket Science 104
- Velocity ~ 105
- 106 E-MU Systems 106
- Programming Basics 106
- Preset Modulation Processors 106
- Dynamic 109
- Low Pass 110
- Low Q Med Q High Q 111
- Frequency 112
- Amplitude 112
- Parametric 113
- 114 E-MU Systems 114
- Dynamic Filters 114
- Instrument 115
- Z-Plane Filter 115
- MIDI Channels 116
- Real-time 116
- Controls 116
- MIDI BANK SELECT 118
- Stereo Mix 119
- Send (1-4) or to “Preset” 120
- Edit Menu 121
- PRESET NAME 122
- syn: VOSIM-Voc 122
- Four Layer 123
- Architecture 123
- Defining 124
- Parameters 124
- Edit Menu 125
- Defining Layer Parameters 125
- C0 C1 C2 C3 C4 C5 C6 126
- Switch Switch Switch 126
- Defining the Velocity 128
- Crossfade Range 128
- 3 128
- Increasing Velocity0 129
- Layer 2Layer 1 129
- 130 E-MU Systems 130
- Realtime Control Value 131
- 127112968064483216 131
- 132 E-MU Systems 132
- 134 E-MU Systems 134
- = Initial Setting 135
- = Increase Master Tempo 135
- = Decrease Master Tempo 135
- Tempo-Based Envelopes 135
- (using factory envelope) 136
- ASSIGN GROUP 139
- 140 E-MU Systems 140
- Xtreme Lead Filter 141
- FILTER 143
- Freq: 2 143
- 55 Q: 019 143
- To Turn on Envelope Repeat: 144
- Low Frequency 145
- Oscillators (LFOs) 145
- (two cords) 146
- LFO Synced to 1/4 Note Clock 147
- Variation 149
- 150 E-MU Systems 150
- PatchCords 150
- Control Value Applied 151
- LFO 1 & 2 Trigger 152
- Preset Effects 155
- FXA ALGORITHM 156
- Lg Concert Pan 156
- B Effect Types 157
- 158 E-MU Systems 158
- FXB Parameters 158
- Initial Controller 160
- INITIAL CONTROLLER AMT 160
- Preset Links 163
- Programming Tutorial 165
- 166 E-MU Systems 166
- Editing Presets 166
- To Chorus a Layer 167
- To Setup the Volume Envelope 168
- Adding the Filter Envelope 170
- To Setup the Filter Envelope 170
- Changing Filter Types 172
- Envelope Repeat 173
- Linking 175
- 176 E-MU Systems 176
- Linking Presets 176
- Effects 177
- 178 E-MU Systems 178
- Effects Overview 178
- A Effect Types 179
- High Frequency Damping 180
- Feedback 180
- LFO Rate 180
- Programmed 181
- 182 E-MU Systems 182
- Master Effects 182
- Flexible Effects 184
- “multi” for the mode 185
- FX MULTIMODE CONTROL 186
- Effect B 187
- Effect A 187
- General Effect 188
- Descriptions 188
- General Effect Descriptions 189
- 190 E-MU Systems 190
- Save/Copy Menu 191
- Copying 192
- Information 192
- COPY CORDS User 193
- Source Preset 193
- To Copy a Preset PatchCord 194
- To Copy a Preset Bank 195
- Restoring 196
- Multisetups 196
- RESTORE MULTISETUP 196
- 03 Jazz Encounter 196
- To Save a Multisetup: 197
- Create Random 198
- Any User Preset 198
- To Copy a User Bank to Flash 199
- 202 E-MU Systems 202
- Front Panel 203
- Functions 203
- XL-1 Preset 204
- Categories 204
- User Bank 0, XLEAD Bank 0 205
- User Bank 1, XLEAD Bank 1 206
- User Bank 2, XLEAD Bank 2 207
- User Bank 3, XLEAD Bank 3 208
- Riff Listing 209
- Instrument Listing 212
- Trigger 221
- Trigger Layout 2 222
- Trigger Layout 3 222
- Trigger Layout 4 223
- Velocity 224
- Velocity Curves 225
- PatchCord 226
- Amount Chart 226
- MIDI Implementation Chart 227
- MIDI Device Inquiry Responses 228
- Received Channel 229
- Commands 229
- Technical 230
- Specifications 230
- Warranty 231
- Restrictions 231
- How To Obtain 231
- Warranty Service 231
- 232 E-MU Systems 232
- Appendix 232
- Numerics 233
Related products and manuals for Synthesizer E-Mu Xtreme Lead-1
Synthesizer E-Mu Morpheus Specifications
(248 pages)
(248 pages)
Synthesizer E-Mu Xboard 49 User Manual
(4 pages)
(4 pages)
© 2020, manymanuals.com. All rights reserved. | 0.164 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals