E-Mu SP1200 Specifications download pdf (Page 144)

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),

or other means of dissemination may be made without written permission.

3BUS 208 000 R1301122 Measurement Setup

Enter Calibration Head Constants

Calibration head constants have to be entered into the Scanning Platform software.

The values for these constants can be found on reports for the Basis Weight (includes

Air Column), and Ash sensors or tags for the IR Moisture and Caliper sensors. For

the OptiPak and Gloss sensor, values are entered through an interactive genrpt

program that allows the software to calibrate the constants it needs on line.

Basis Weight Sensor

The Basis Weight sensor head constants are K0, K1, K2, K3, WCC, and AM. These

constants may be different for every sensor. They may need to be changed if certain

components in the sensor geometry are repaired or replaced. Change sensor

constants using the Basis Weight Health Report, Figure 6-5. See “Operation of NT

Workstation Health Reports” on page 112 for an overview of the Health Reports.

The Basis Weight sensor calibration constants consist of one or two sets of constants.

Table 6-15 lists the head constants for the Basis Weight sensor. Table 6-16 lists the

optional constants and values for the Air Temperature Compensation (ATC).

Table 6-15 Basis Weight Calibration Constants

Head Constant

Value - betaSensor01

(Enter values from the Calibration Report)

WCC

(Smart Basis

Weight only)

(Smart Basis

Weight only)

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 287 288

No comments

E-Mu SP1200 Specifications Page 144