E-Mu SP1200 Specifications download pdf (Page 60)

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),

or other means of dissemination may be made without written permission.

3BUS 208 000 R130138 Hardware Installation

Figure 3-6 Platform to Pedestal Installation – Idler Side

5. Make certain that the mounting surfaces on the bottom of the platform are clean

and smooth.

6. Coat the entire surface on the bottom of the platform with a corrosion preventive

compound.

7. Thread two parallel lengths of wire over the rolls onto which the process is to

be guided. See Figure 3-7 on page 39.

These wires should be placed in the positions that are representative of the

outside edges of the process sheet.

8. Suspend a weight of approximately 5 lb. (3 kg) from each end of the wire.

The top of customer pedestals to

pass line is normally 953 mm

(37.50 in.). For standard end

column includes manufactured

plates and 6 mm (0.25 in.) extended

set screw, (both end columns).

Idler Side

Tighten this screw to 1/2 compression of lock washer. Use

1.25 in. or M30 bolt with lock washer and large flat washer (customer

supplied). Use a thread–locking compound to avoid vibration

loosening. Screw cannot be tightened hard; it is an expansion

mount.

Jack/leveling screws

Base 25 mm (1.0 in.) thick

Steel mounting plate 10

mm (0.375 in.), seating

for set screws

Teflon plate 3 mm (0.125

in.) thick

Tapped holes or

nut on backside

If tapped 1.25” holes are used

in the pedestals instead of

through holes for mounting the

platform, drill and tap 0.375 x

16 or M10 x 1.5 through to

tapped hole for set screw to

lock mounting bolt.

Thermal

Expansion Slot

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 287 288

Comments to this Manuals

No comments

E-Mu SP1200 Specifications Page 60

Comments to this Manuals

Related products and manuals for Recording Equipment E-Mu SP1200