E-Mu SP1200 Specifications download pdf (Page 96)

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),

or other means of dissemination may be made without written permission.

3BUS 208 000 R130174 Platform Tuning

LOCAL/REMOTE

The power-up default mode for the Motor Drive is REMOTE. All values can be

observed in REMOTE. However, values can only be changed when the Drive is in

LOCAL mode.

1. To put the Motor Drive in LOCAL, simultaneously press the MENU and

ENTER push buttons. Note that the LCD shows the new mode.

2. To go back to REMOTE, simultaneously press the MENU and ENTER push

buttons again.

Setting a Parameter Value

1. Go to the desired parameter menu location (see Table 5-1 on page 72).

2. Set the MDPanel to show LOCAL mode.

3. Press the ENTER push button until SET is displayed.

4. Use the UP/DN arrow push buttons to adjust the parameter to the desired value.

When the value is changed, the SET display will blink.

5. Return the MDPanel to REMOTE operations when done.

Downloading Parameters

This operation should only be used to program a new Motor Drive using an MDPanel

which already contains the desired parameter values.

Note: Make sure the MDPanel shows the LOCAL mode.

1. Press the MENU push button to get to the group display.

Do not execute the “-Fd-” menu selection. It will change

the Motor Controller to the ABB Drives factory settings,

not the settings established for ABB scanners.

2. Press the UP arrow push buttons until the display shows “-dL-”.

3. Press and hold the ENTER push button until the display starts to blink. When

the operation is complete, the display will revert back to the power-up display

of output frequency (Hz).

4. Return the control panel to REMOTE operation when done.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 287 288

No comments

E-Mu SP1200 Specifications Page 96